Zilog Z280
The topic of this article may not meet Wikipedia's general notability guideline. (August 2023) |
The Zilog Z280 is a 16-bit microprocessor designed by Zilog as an enhancement of the Zilog Z80 architecture and integrating improvements from the abandoned Zilog Z800 project. First introduced in July 1987, the Z280 is considered to be a commercial failure.
The Z280 was fabricated in CMOS,[1] added a memory management unit (MMU) to expand the addressing range to 16 MB, features for multitasking and multiprocessor and coprocessor configurations, and 256 bytes of on-chip static RAM, configurable as either a cache for instructions and/or data, or as part of the ordinary address space. It has a huge number of new instructions and addressing modes giving a total of over 2000 combinations. It is capable of efficiently handling 32-bit data operations including hardware multiply, divide, and sign extension. It offers Supervisor and User operating modes, and optionally separate address spaces for instructions and data in both modes (four total possible address spaces). Its internal clock signal can be configured to run at 1, 2 or 4 times the external clock's speed (e.g. a 12MHz CPU with a 3 MHz bus). Unlike the Z80 the Z280 uses a multiplexed arrangement for its address and data buses. More successful extensions of the Z80-architecture include the Hitachi HD64180 in 1986 and Zilog eZ80 in 2001, among others.
The Z280 had many advanced features for its time, most of them never seen again on a Zilog processor:[2]
- On-chip instruction and/or data cache, or on-chip RAM
- Instruction pipelining
- High performance 16-bit Z-BUS interface or 8-bit Z80-compatible bus interface
- Built-in MMU with memory protection
- Ability to determine which register set is in context with instructions JAF and JAR
- Three on-chip 16-bit counter/timers
- Four on-chip DMA channels
- On-chip full duplex UART
- User I/O trap
- Supervisor mode (privileged instructions)
- Illegal instruction trap[citation needed]
- Coprocessor emulation trap
- Burst mode memory access
- Multiprocessor support, with many bus configuration modes
- Support for multiple external coprocessors through an accelerated communication interface
- Multiple I/O pages, which also allows for internal I/O devices without restricting the address range of the I/O ports like on eZ80, or conflicting with existing motherboard devices, like the Z180.
- Stack overflow warning
In the early 1990s, a small number of single-board computers based on the Zilog Z280 were designed and produced by Tilmann Reh, but the CPU was never used in any commercially produced computer.[3]
In 2016, Lamar Owens contacted Tilmann Reh and obtained permission to have a small new run of the CPU280 system PCB's created, getting ten boards made and distributed to several beta builders. Wayne Warthen developed a build setup to rebuild the EPROM images and floppy disk images, and set up a page at Github for distribution and development. In spring 2018, another ten boards were made.[4]
References
[edit]- ^ EDN November 27, 1986 p133
- ^ Z280 MPU Microprocessor Unit Preliminary Technical Manual (PDF). San Jose, California: Zilog. 1989. Archived from the original (PDF) on 2019-09-11. Retrieved 2009-07-15.
- ^ "CPU280 System Software". Retrieved 2024-11-10.
- ^ "CPU280". Retrieved 2024-11-10.
- Z80 Family Data Book. San Jose, California: Zilog. January 1989.
- Reh, Tilmann (1991-09-16). "The CPU280 and Z280". TCJ. Retrieved 2009-07-15.
Further reading
[edit]- Harston, J.G. (1998-04-15). "Full Z280 Opcode List". Retrieved 2009-07-15.